Skip to content
608 Practice Test

Flashcards

Look at the term. Do you know what it means? Tap the card. 109 terms from the lessons.

0 of 109 terms known

All terms by topic

Ozone depletion and refrigerant types

Lesson: EPA 608 Core: ozone depletion and refrigerant types (CFC, HCFC, HFC)

Stratosphere:
The atmosphere layer from about 10 to 50 km up; it holds most of the ozone.
Troposphere:
The lowest layer of the atmosphere, where weather happens.
UVB:
Ultraviolet light from the sun that ozone mostly absorbs; linked to skin cancer and cataracts.
CFC:
Chlorofluorocarbon, such as R-12; contains chlorine and has the highest ozone damage.
HCFC:
Hydrochlorofluorocarbon, such as R-22; contains chlorine but damages ozone much less than a CFC.
HFC:
Hydrofluorocarbon, such as R-134a or R-410A; no chlorine, so zero ozone depletion.
ODP:
Ozone depletion potential: harm to ozone compared with CFC-11 (1.0).
GWP:
Global warming potential: warming effect compared with carbon dioxide.
Clean Air Act, Montreal Protocol and Section 608 rules

Lesson: EPA 608 Core: Clean Air Act, Montreal Protocol and Section 608 rules

Montreal Protocol:
International treaty phasing out ozone-depleting substances; signed by the U.S. in 1987.
Venting prohibition:
Ban on knowingly releasing refrigerant during service, repair or disposal.
De minimis release:
A very small loss during good-faith recovery that follows the rules; not a violation.
Sales restriction:
Only certified technicians, or employers of one, may buy refrigerant (with narrow exceptions).
Final processor:
The last link before final disposal, for example a scrap recycler or a landfill.
Leak rate:
The share of the full charge an appliance would lose over 12 months at its current loss rate.
Substitute refrigerants, oils and the HFC phase-down

Lesson: EPA 608 Core: substitute refrigerants, oils, blends and the HFC phasedown

Substitute:
A refrigerant used in place of a CFC or HCFC, such as an HFC, HFO, hydrocarbon, ammonia or CO2.
Drop-in:
A replacement that needs no system changes; EPA says there are none.
Retrofit:
Converting an appliance to a different refrigerant, often with new oil and seals.
Ester oil:
Lubricant EPA pairs with the HFC R-134a.
Alkylbenzene:
Lubricant EPA pairs with HCFCs such as R-22.
Fractionation:
Parts of a refrigerant blend leaking at different rates, changing the mix left behind.
AIM Act:
2020 U.S. law that phases down HFCs and sets rules on leaks and reclaim.
Kigali Amendment:
Addition to the Montreal Protocol that phases down HFCs worldwide.
Refrigeration cycle, gauges and leak detection

Lesson: EPA 608 Core: the refrigeration cycle, pressure classes and leak checks

Evaporator:
Where liquid refrigerant boils to vapor and absorbs heat; the cooling coil.
Condenser:
Where hot refrigerant gas gives off heat and turns into liquid.
Compressor:
Raises the pressure of refrigerant vapor and moves it round the system.
Receiver:
A vessel that stores liquid refrigerant.
Suction accumulator:
Keeps liquid refrigerant out of the compressor suction.
psia:
Pounds per square inch absolute, the scale EPA uses for pressure classes.
Low-pressure appliance:
Uses a refrigerant below 45 psia at 104 °F, such as R-123.
High-pressure appliance:
Uses a refrigerant between 170 and 355 psia at 104 °F, such as R-410A.
Recover, recycle, reclaim and evacuation

Lesson: EPA 608 Core: recover, recycle, reclaim and evacuation basics

Recover:
Remove refrigerant and store it in an outside container, with no testing or cleaning required.
Recycle:
Clean refrigerant with oil separation and filter-driers for reuse by the same owner.
Reclaim:
Reprocess refrigerant to AHRI 700-2016 purity and verify it by analysis.
Certified reclaimer:
A business certified by EPA to reclaim refrigerant for sale to new owners.
Self-contained recovery equipment:
A recovery machine that works without the appliance's components.
System-dependent recovery equipment:
Recovery equipment that relies on the appliance's own parts; limited to appliances of 15 pounds or less unless permanently attached.
Dehydration evacuation:
Pulling a vacuum at the end of service to remove air and moisture.
AHRI Standard 700-2016:
The refrigerant purity standard behind EPA's reclaim specifications.
Safety, cylinders and shipping

Lesson: EPA 608 Core: refrigerant safety, cylinders, nitrogen and shipping

Asphyxia:
Suffocation; can happen when heavy refrigerant vapor displaces oxygen.
Cardiac arrhythmia:
An irregular heartbeat; a possible effect of breathing high refrigerant levels.
Frostbite:
Freezing injury to skin or eyes from contact with liquid refrigerant.
SCBA:
Self-contained breathing apparatus, used in extreme exposure situations.
Recovery cylinder:
A reusable, DOT-approved cylinder coded yellow and gray.
Disposable cylinder:
A one-trip cylinder of new refrigerant; never refilled.
Heel:
The refrigerant left in a used cylinder; the rule calls it the heel or residue.
Relief valve:
A valve that opens to stop pressure going too high, used with nitrogen regulators.
Small appliances: definition and recovery requirements

Lesson: EPA 608 Type I: what counts as a small appliance and how much refrigerant to recover

Small appliance:
An appliance built, charged and sealed in a factory with 5 pounds or less of refrigerant.
Process stub:
A piece of tubing that gives access to the refrigerant and is resealed after service.
November 15, 1993:
The recovery equipment manufacture date that decides whether 80 or 90 percent applies.
4 inches Hg vacuum:
Vacuum level that meets the small-appliance recovery rule in every case.
Final processor:
Whoever takes the last step in disposal, for example a scrap yard or landfill.
De minimis release:
A tiny release during good faith recovery with the required practices; not a violation.
Mail-in Type I:
Open-book Type I test that passes at 84 percent and does not count toward Universal.
Small appliances: recovery techniques

Lesson: EPA 608 Type I recovery techniques: passive recovery, access valves and the test stand

System-dependent (passive) recovery:
Recovery that relies on the appliance's own parts, such as its compressor.
Self-contained recovery:
Recovery equipment that works without help from the appliance.
Solderless access fitting:
A bolt-on fitting used to reach the refrigerant; remove it after service.
Noncondensables:
Gases such as air that do not turn to liquid in the system and raise pressure.
Recover:
Take refrigerant out and store it in an outside container, in any condition.
Recycle:
Clean refrigerant for reuse by the same owner, short of full reclaim purity.
Recovery efficiency:
Recovered amount divided by recoverable amount, times 100.
Small appliances: safety and refrigerants

Lesson: EPA 608 Type I safety: refrigerant breakdown by heat and flammable R-600a and R-290

Phosgene:
Highly toxic gas that can form when CFC or HCFC refrigerant meets a flame or hot metal.
Thermal decomposition:
Breakdown of a refrigerant into other chemicals caused by high heat.
R-600a (isobutane):
Flammable hydrocarbon refrigerant common in new household refrigerators.
R-290 (propane):
Flammable hydrocarbon refrigerant used in some new refrigerators, coolers and room air conditioners.
Lower flammability limit (LFL):
The lowest concentration in air at which a gas can burn.
Spark-proof tools:
Tools that will not create sparks; EPA's use conditions call for them on hydrocarbon units.
Class B extinguisher:
Fire extinguisher type for flammable liquids and gases.
High-pressure: leak detection and leak repair

Lesson: EPA 608 Type II: finding leaks and the leak repair rules

Leak rate:
Percent of the full charge that would be lost in a year at the current rate of loss.
Full charge:
The refrigerant amount the appliance needs to run normally.
Trigger rate:
The leak rate above which repair is required: 20, 30 or 10 percent.
Industrial process refrigeration:
Systems tied to industrial processes, plus ice rinks and industrial ice machines.
Initial verification test:
A leak test right after the repair, before refrigerant goes back in.
Follow-up verification test:
A second check within 10 days, once the system runs normally.
Seasonal variance:
Refrigerant removed for a season and later returned in the same or a smaller amount within 12 months.
High-pressure: recovery requirements and techniques

Lesson: EPA 608 Type II: required evacuation levels and recovery techniques

High-pressure appliance:
Uses a refrigerant with a liquid saturation pressure of 170 to 355 psia at 104 °F, such as R-410A or R-22.
Table 1:
The chart in 40 CFR 82.156 that sets the vacuum level to reach before opening or disposing of an appliance.
Major repair:
Removing the compressor, condenser, evaporator or an auxiliary coil, or leaving more than 4 sq in open for over 15 minutes.
System receiver:
The isolated part or vessel of an appliance that holds the charge while another part is serviced.
System-dependent recovery:
Recovery that relies on the appliance's own parts, such as its compressor; limited to systems of 15 pounds or less.
Recycle:
Clean refrigerant, for example with filter-driers, for reuse by the same owner.
Reclaim:
Reprocess refrigerant to the AHRI 700 purity standard and verify it; needed before it changes owner.
High-pressure: safety, charging and disposal

Lesson: EPA 608 Type II: safety, charging and disposal

SCBA:
Self-contained breathing apparatus: a breathing set with its own air supply, for extreme cases such as low oxygen.
Oxygen deprivation:
Not enough oxygen to breathe, which can happen when leaking refrigerant displaces air in a closed room.
ASHRAE Standard 15:
The safety standard for refrigeration systems that sets equipment room requirements, such as sensors.
Recovery cylinder:
A reusable, DOT-approved cylinder, gray with a yellow top, for holding recovered refrigerant.
Disposable cylinder:
A one-trip cylinder for new refrigerant; it must never be refilled.
Heel:
The refrigerant left in a cylinder after normal use.
psia:
Pounds per square inch absolute: the gauge reading (psig) plus 14.7.
Low-pressure: leak detection and leak repair

Lesson: Type III leak testing and leak repair for low-pressure chillers

Low-pressure appliance:
Uses a refrigerant whose liquid saturation pressure is under 45 psia at 104°F, such as R-11 or R-123.
Purge unit:
Device on a low-pressure chiller that removes air and water; heavy purge running points to a leak.
Rupture disc:
Safety disc on the evaporator that protects the shell; on many chillers it bursts at about 15 psig.
Trigger leak rate:
Yearly leak rate above which repairs are required: 10%, 20% or 30% depending on the appliance type.
Initial verification test:
Leak test right after a repair, before refrigerant goes back in when the system was evacuated.
Follow-up verification test:
Second check within 10 days, once the chiller runs normally, that the repair held.
Chronically leaking appliance:
One that loses 125% or more of its full charge in a calendar year; it must be reported to EPA.
Low-pressure: recovery, recharging and evacuation

Lesson: Type III recovery, evacuation and recharging of low-pressure chillers

25 mm Hg absolute:
Required recovery level for every low-pressure appliance, about 29 inches of mercury vacuum.
Major repair:
Removes the compressor, condenser, evaporator or auxiliary coil, or leaves over 4 sq in open for over 15 minutes.
0 psig:
Atmospheric pressure; the highest pressure allowed when opening a low-pressure chiller for a non-major repair.
Controlled hot water:
Warm water run through the tubes to raise refrigerant pressure without adding gas.
Evaporator charging valve:
The usual point for charging refrigerant into a centrifugal chiller.
Pump-out unit:
Recovery equipment permanently attached to a chiller; the only system-dependent equipment allowed over 15 lb.
Reclaim:
Reprocess refrigerant to the AHRI 700 purity standard; needed when recovered refrigerant changes owner.
Low-pressure: safety and purge units

Lesson: Type III safety: machinery rooms, purge units and low-pressure refrigerants

ASHRAE Standard 15:
Safety standard for refrigeration systems, including machinery room sensors, alarms and ventilation.
Oxygen-deprivation sensor:
Monitor that warns when refrigerant has pushed out breathable air; EPA's topic list ties it to all refrigerants.
Refrigerant sensor (detector):
Continuous monitor for refrigerant in the room; required for R-123 under ASHRAE 15.
Non-condensables:
Gases such as air that do not turn to liquid in the condenser and raise head pressure.
Purge unit:
Device that removes non-condensables and water from a low-pressure chiller.
Asphyxiation:
Suffocation when refrigerant vapor displaces the oxygen in a room.
Saturation pressure:
Pressure of a refrigerant with liquid and vapor together at a given temperature; it rises as temperature rises.

Questions people ask

Are the flashcards free?

Yes. No account needed. The cards you mark as known are saved on this device.

Where do the terms come from?

From our free lessons, one per topic of the test. Each lesson lists its official sources.